Rjs Inspector D4000 Laser (FIRMWARE version A.05 and E Instrukcja Użytkownika

Laser Inspector Model L1000TM Operator’s Guide Manual P/N 002-5568 Release Version: G June 2011 RJS Technologies 701 Decatur Ave No

Model L1000 Laser InspectorTM Operator’s Guide RJS, Minneapolis, MN 002-5568 4 2.0 Warranty 2.1 General Warranty Warranty information: (763) 746

Operator’s Guide Model L1000 Laser InspectorTM 002-5568 RJS, Minneapolis, MN 5 2.3 Service During The Warranty Period If your Laser Inspector sho

Model L1000 Laser InspectorTM Operator’s Guide RJS, Minneapolis, MN 002-5568 6 3.0 Introduction 3.1 Warnings  Do not point the laser gun in th

Operator’s Guide Model L1000 Laser InspectorTM 002-5568 RJS, Minneapolis, MN 7 3.2 Maintenance To ensure the best possible scanning conditions, k

Model L1000 Laser InspectorTM Operator’s Guide RJS, Minneapolis, MN 002-5568 8 4.0 The Laser Inspector Figure 4-1 (Laser InspectorModel L1000)

Operator’s Guide Model L1000 Laser InspectorTM 002-5568 RJS, Minneapolis, MN 9 5.0 Main Menu Selections Note: Even though your Inspector may

Model L1000 Laser InspectorTM Operator’s Guide RJS, Minneapolis, MN 002-5568 10 5.2 Setup Select Setup (from the Main Menu) to set various system

Operator’s Guide Model L1000 Laser InspectorTM 002-5568 RJS, Minneapolis, MN 11 The next selection is; UPC/EAN Rnd. Wt. OFF Note: Select ON to a

Model L1000 Laser InspectorTM Operator’s Guide RJS, Minneapolis, MN 002-5568 12 The next selection is: Decode I 2of 5 ANSI I 2 of 5 This allows

Operator’s Guide Model L1000 Laser InspectorTM 002-5568 RJS, Minneapolis, MN 13 The next selection is : Database Storage XX kb XX kb Enter

Copyrights The copyrights in this manual are owned by RJS Technologies, Inc. All rights are reserved. Unauthorized repr

Model L1000 Laser InspectorTM Operator’s Guide RJS, Minneapolis, MN 002-5568 14 The last menu setup selection is: Comparison Mode OFF Note: Com

Operator’s Guide Model L1000 Laser InspectorTM 002-5568 RJS, Minneapolis, MN 15 5.3 Storage Storage is used to hold scan data for future print or

Model L1000 Laser InspectorTM Operator’s Guide RJS, Minneapolis, MN 002-5568 16 5.4 Storage and Database A special serial interface cable th

Operator’s Guide Model L1000 Laser InspectorTM 002-5568 RJS, Minneapolis, MN 17 The database function is defaulted to OFF and becomes active when

Model L1000 Laser InspectorTM Operator’s Guide RJS, Minneapolis, MN 002-5568 18 Database XX Storage YY The cursor will be on the “D” in dat

Operator’s Guide Model L1000 Laser InspectorTM 002-5568 RJS, Minneapolis, MN 19 6.0 Scanning Symbols To scan a barcode simply pull the trigger a

Model L1000 Laser InspectorTM Operator’s Guide RJS, Minneapolis, MN 002-5568 20 7.0 Pass/Fail Analysis Screen After a symbol is scanned the Pass/

Operator’s Guide Model L1000 Laser InspectorTM 002-5568 RJS, Minneapolis, MN 21 Table 1 (Code Identifiers Laser Inspector ) Displays Type LOGMA

Model L1000 Laser InspectorTM Operator’s Guide RJS, Minneapolis, MN 002-5568 22 Table 2 (Identifier Descriptions for Pass/Fail Analysis Screens)

Operator’s Guide Model L1000 Laser InspectorTM 002-5568 RJS, Minneapolis, MN 23 8.0 Data Analysis Screens After doing a scan, the Data Analysis S

Operator’s Guide Models L1000 Laser InspectorTM 002-5568 iii RJS, Minneapolis, MN TABLE OF CONTENTS 1.0 PREFACE 1 1.1 PROPRIETARY STATEMENT 1

Model L1000 Laser InspectorTM Operator’s Guide RJS, Minneapolis, MN 002-5568 24 For Code 128, the Mod check character is displayed as the symbolog

Operator’s Guide Model L1000 Laser InspectorTM 002-5568 RJS, Minneapolis, MN 25 Press Select to bring up the next screen: Ratio: 2.9 D/bility .

Model L1000 Laser InspectorTM Operator’s Guide RJS, Minneapolis, MN 002-5568 26 The closer the “A” is to the edge, the more likely a Warning or Re

Operator’s Guide Model L1000 Laser InspectorTM 002-5568 RJS, Minneapolis, MN 27 Press Select again to display the first technical Data Analysis sc

Model L1000 Laser InspectorTM Operator’s Guide RJS, Minneapolis, MN 002-5568 28 8.1 Continuous and Multi-scan modes In the Continuous Mode, an add

Operator’s Guide Model L1000 Laser InspectorTM 002-5568 RJS, Minneapolis, MN 29 9.0 Connect to other Devices Connect to Computer Your Laser Inspe

Appendix A Operator’s Guide RJS, Minneapolis, MN 002-5568 30 Appendix A (Code 128) Code 128 Code 128 can encode all the characters currentl

Operator’s Guide Appendix A 002-5568 RJS, Minneapolis, MN 31 Due to the flexibility and nature of Code 128, it is difficult to display “printa

Appendix A Operator’s Guide RJS, Minneapolis, MN 002-5568 32 Example: * C L C 1 3 ? * A A B 3 R F C 2 4 ? * Re

Operator’s Guide Appendix A 002-5568 RJS, Minneapolis, MN 33 Note: Only the first and last alphanumerics of each ASCII character are display

Model L1000 Laser InspectorTM Operator’s Guide RJS, Minneapolis, MN 002-5568 iv 5.0 MAIN MENU SELECTIONS 9 5.1 SCAN 9 5.2 SETUP 10 5.3 STOR

Appendix A Operator’s Guide RJS, Minneapolis, MN 002-5568 34 Table A-2 (Code 128 — Subset B) SP ! " # $ % & '

Operator’s Guide Appendix A 002-5568 RJS, Minneapolis, MN 35 Table A-3 (Code 128 — Subset C) 00 01 02 03 04 05 06 07 08

Appendix A Operator’s Guide RJS, Minneapolis, MN 002-5568 36 Note: On the LCD Display the Inspector will show a Yen symbol “¥”instead of a backs

Operator’s Guide Appendix B 002-5568 RJS, Minneapolis, MN 37 Appendix B (Code 93) Code 93 Code 93 encodes 43 data characters consisting of 0-9, A

Appendix B Operator’s Guide RJS, Minneapolis, MN 002-5568 38 * is substituted for Stop/Start characters < is substituted for encircled

Operator’s Guide Appendix B 002-5568 RJS, Minneapolis, MN 39 Table B-1 (Code 93 Character Set) ASCII CODE 93 ASCII CODE 93 ASCII CODE 93 ASC

Appendix C Operator’s Guide RJS, Minneapolis, MN 002-5568 40 Appendix C (Battery Displays) Battery Displays If the “Low Battery” condition displ

Operator’s Guide Appendix D 002-5568 RJS, Minneapolis, MN 41 Appendix D (Magnifications) UPC/EAN Magnifications & Bar Width Deviations UPC a

Appendix E Operator’s Guide RJS, Minneapolis, MN 002-5568 42 Appendix E (Print Functions) Print Functions Scanned data may be printed if the Las

Appendix E Operator’s Guide 002-5568 RJS, Minneapolis, MN 43 Figure E-1 (Continuous scan) Laser Inspector L1000 Rev. X Cont. Scan Analysis ANS

Operator’s Guide Models L1000 Laser InspectorTM 002-5568 v RJS, Minneapolis, MN TABLE A-2 (CODE 128 — SUBSET B) 34 TABLE A-2 (CODE 128 — SUB

Appendix F Operator’s Guide RJS, Minneapolis, MN 002-5568 44 Appendix F (Symbology Analysis) Symbology Analysis Parameters Table F-1 shows error

Operator’s Guide Appendix F 002-5568 RJS, Minneapolis, MN 45 Table F-2, (Parameters Checked for Each Symbology) Symbology Ratio ICG Data Cha

Appendix F Operator’s Guide RJS, Minneapolis, MN 002-5568 46 NOTES: 1. X = X dimension 2. Tolerance is expressed as a fraction of the X dimensi

Operator’s Guide Appendix G 002-5568 RJS, Minneapolis, MN 47 Appendix G (ANSI Decodability) ANSI Decodability Calculations There is a specified me

Appendix G Operator’s Guide RJS, Minneapolis, MN 002-5568 48

Operator’s Guide Appendix H 002-5568 RJS, Minneapolis, MN 49 Appendix H (Scanning Technique) The RJS Inspector bar code verifier that is supplied

Appendix H Operator’s Guide RJS, Minneapolis, MN 002-5568 50 Figure 1 – Scanning angle and distance

Operator’s Guide Appendix I 002-5568 RJS, Minneapolis, MN 51 Appendix I (Quiet Zone Analysis) Quiet Zone Analysis The Laser Inspector trims d

Appendix I Operator’s Guide RJS, Minneapolis, MN 002-5568 52 Table I-2 (Acceptable Parameters for Symbols With Addendums) Symbology Leading Q

Operator’s Guide Appendix J 002-5568 RJS, Minneapolis, MN 53 Appendix J Downloading the Database See also 5.4 Storage and Database Database Se

Model L1000 Laser InspectorTM Operator’s Guide RJS, Minneapolis, MN 002-5568 vi APPENDIX G (ANSI DECODABILITY) 47 ANSI DECODABILITY CALCULATIONS

Appendix J Operator’s Guide RJS, Minneapolis, MN 002-5568 54 (You can have many records (like the record above), stacked in a file. The start cha

Operator’s Guide Appendix J 002-5568 RJS, Minneapolis, MN 55 Step 5) Using the COPY command, download the sample data base: COPY DBSAMP

Appendix J Operator’s Guide RJS, Minneapolis, MN 002-5568 56 Data Base Record Does Not Exist (If the scanned symbol does not match the rec

Operator’s Guide Appendix J 002-5568 RJS, Minneapolis, MN 57 EAN-13 The EAN-13 database key must be made up of all 13 digits in the barcode (inclu

Appendix J Operator’s Guide RJS, Minneapolis, MN 002-5568 58 Code 93 The Code 93 database key must be made up of all the printable data characters

Appendix K Operator’s Guide 002-5568 RJS, Minneapolis, MN 59 Appendix K Barcode Definitions (Some of these definitions may not be applicable to t

Appendix K Operator’s Guide RJS, Minneapolis, MN 002-5568 60 Barcode A group of parallel bars and spaces constituting characters that are machin

Appendix K Operator’s Guide 002-5568 RJS, Minneapolis, MN 61 Bit The narrowest code element (bar of space) that may contain information. Characte

Appendix K Operator’s Guide RJS, Minneapolis, MN 002-5568 62 Decode Determining the information which has been encoded in a barcode symbol. Deco

Appendix K Operator’s Guide 002-5568 RJS, Minneapolis, MN 63 Element A generic term used to refer to either a bar or space in a barcode symbol. E

Operator’s Guide Model L1000 Laser InspectorTM 002-5568 RJS, Minneapolis, MN 1 1.0 Preface 1.1 Proprietary Statement The RJS Model L1000 Laser I

Appendix K Operator’s Guide RJS, Minneapolis, MN 002-5568 64 Fixed Beam Scanner A barcode reading device wherein coded items pass across a statio

Appendix K Operator’s Guide 002-5568 RJS, Minneapolis, MN 65 Infinite Pad Method The method for measuring reflectance in which the sample substrat

Appendix K Operator’s Guide RJS, Minneapolis, MN 002-5568 66 Maximum Element Reflectance Nonuniformity (ERN max) The largest element reflectance

Appendix K Operator’s Guide 002-5568 RJS, Minneapolis, MN 67 MOD = ECmin/SC The greater the difference between minimum edge contrast and symbol c

Appendix K Operator’s Guide RJS, Minneapolis, MN 002-5568 68 No-Read (Non-read, Non-scan) The absence of data at the scanner output after an atte

Appendix K Operator’s Guide 002-5568 RJS, Minneapolis, MN 69 Peak The graphical pattern on a scan reflectance profile which looks like an upside d

Appendix K Operator’s Guide RJS, Minneapolis, MN 002-5568 70 Reference Decode Each symbology type specifies a specific decoding method to

Appendix K Operator’s Guide 002-5568 RJS, Minneapolis, MN 71 Scanner An electronic device that converts printed information into electrical signal

Appendix K Operator’s Guide RJS, Minneapolis, MN 002-5568 72 Specular Reflection Reflection of light from a surface at an angle equal and oppos

Appendix K Operator’s Guide 002-5568 RJS, Minneapolis, MN 73 Symbol Grade The simple average of all the overall profile grades using the standard

Model L1000 Laser InspectorTM Operator’s Guide RJS, Minneapolis, MN 002-5568 2 1.5 Documentation Updates RJS strives to provide the best possible

Appendix K Operator’s Guide RJS, Minneapolis, MN 002-5568 74 Truncation Decreasing the length of the bars in a barcode symbol below the normal sp

Appendix K Operator’s Guide 002-5568 RJS, Minneapolis, MN 75 Z Dimension The achieved width of the narrow elements. Computation of Z is accomplis

Operator’s Guide Model L1000 Laser InspectorTM 002-5568 RJS, Minneapolis, MN 3 Remove batteries when the unit will not be used for a pe